73 Results Found
  • Only Show:
4,286 views

PD1:Sketch Based Features (Part-1)

Sketch Based Features (Part-1)In this lesson You will learn,PadNormal to sketch.Pad.Normal to sketch.Extrusion along direction.Extruding open profile.Extruding Sub Elements of a

2.0 1 review
1,595 views

SD16:Operations on Surfaces (Part -1)

Operations on Surfaces (Part -1)In this Video training lesson You will learnJoin Geometry.Selection modes.Check Selection.Merging distance.Healing Geometry.

Not yet reviewed!
2,068 views

PD2:Sketch Based Features (Part-2)

Sketch Based Features (Part-2).In this lesson You will learn,Pocket.Normal to sketch.Pocket along direction.Pocket using open profile.Pocket using Sub Elements of a sketch.Relimitation

Not yet reviewed!
1,414 views

SD17:Operations on Surfaces (Part -2)

Operations on Surfaces (Part -2)In this Video training lesson You will learnSplitKeeping or Removing ElementsSplitting WiresSplitting a surface by a curveSplitting surface by a sur

Not yet reviewed!
2,038 views

PD3:Sketch Based Features (Part-3)

In this lesson You will learn,Shaft.Shaft from Closed Profile.Shaft with thick option.Shaft from Surface.Groove.Groove from open profile.Groove from thick option.Groove from surface.

Not yet reviewed!
1,404 views

SD18:Operations on Surfaces (Part -3)

Operations on Surfaces (Part -3)In this Video training lesson You will learnTrimModes of trimming.Trimming Wires.Trimming Surfaces.

Not yet reviewed!
1,659 views

PD4:Sketch Based Features (Part-4)

Sketch Based Features (Part-4).In this lesson You will learn,Holes.Simple hole.Counter bored hole.Counter sunk hole.counter drilled hole.Threaded Hole.

5.0 1 review
1,574 views

SD19:Operations on Surfaces (Part -4)

Operations on Surfaces (Part -4)In this Video training lesson You will learnShape filletBiTangent Fillet.Tritangent fillet.Edge filletKeeping Edges.Limiting Fillets.Trimming

Not yet reviewed!
1,551 views

PD5:Sketch Based Features (Part-5)

Sketch Based Features (Part-5)In this lesson You will learn,Rib.Creation of Rib.Thin Ribs.Profile control options.Slots.creation of Slots.Thin Slots.Profile control options.

Not yet reviewed!
1,447 views

SD20:Operations on Surfaces (Part -5)

Operations on Surfaces (Part -5)In this Video training lesson You will learnVariable radius fillet.Face-Face fillet.Tritangent fillet.

Not yet reviewed!